Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-F700P ]

191-200 of Total 294

prev 20 / 30page next

  • CC-Link

    It is OK if stations are set as reserved. More Details >>

    • No：21868
    • Release Date：2018/08/22 16:29

  • CC-Link

    If Pr.544 (CC-Link extended setting) is set to other than "0", you do not need to change Pr.544 (CC-Link extended setting).Write the extended setting of the ... More Details >>

    • No：21834
    • Release Date：2018/08/22 16:29

  • CC-Link

    The start commands cannot be input from both sources simultaneously because the operation command source is specified.You can switch the command source as ne... More Details >>

    • No：21828
    • Release Date：2018/08/22 16:29

  • CC-Link

    Turn ON the monitor command RYC. More Details >>

    • No：21826
    • Release Date：2018/08/22 16:29

  • Operation stop, frequency setting

    Set Pr.79 (Operation mode) to "1" (PU operation mode).　 More Details >>

    • No：21819
    • Release Date：2018/08/22 16:29

  • Frequency setting

    In this case, the JOG operation is prioritized.When the terminals JOG and SD are short-circuited and turned ON, the frequency setting by the external potenti... More Details >>

    • No：21804
    • Release Date：2018/08/22 16:29

  • Terminal FM meter connection

    Check the connection with the meter.If the terminal FM is connected to the positive terminal and the terminal SD is connected to the negative terminal of the... More Details >>

    • No：21762
    • Release Date：2018/08/22 16:29

  • Frequency setting

    No. You cannot change the setting during operation.However, setting Pr.77 (Parameter write selection) to "2" allows for the setting change during operation. ... More Details >>

    • No：21734
    • Release Date：2018/08/22 16:29

  • Frequency setting

    For the set frequency 60 Hz, ±6 Hz is applied and thus the up to frequency signal is output between 54 Hz and 66 Hz. During acceleration/deceleration to the ... More Details >>

    • No：21348
    • Release Date：2018/08/22 16:27

  • Parameter

    Press the "MODE" key on the operation panel several times to display "P.0" and parameter setting screen. Then turn the setting dial to display "C..." screen ... More Details >>

    • No：21336
    • Release Date：2018/08/22 16:27

191-200 of Total 294

Inquiries

Contact Us

page top