Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-F700P ]

241-250 of Total 295

prev 25 / 30page next

  • Switching between PU and NET operations

    Even after setting Pr.340 to "10", the change is reflected after resetting the power supply.Perform the power reset.Since changes to the communication parame... More Details >>

    • No：21696
    • Release Date：2018/08/22 16:28

  • CC-Link

    Connect the wire to the optional FR-A7NC's terminal block. (The terminal block is detachable.) More Details >>

    • No：21875
    • Release Date：2018/08/22 16:29

  • Program command

    This subroutine is to check the data link status and needs to be executed only once at the start of the program. More Details >>

    • No：21767
    • Release Date：2018/08/22 16:29

  • CC-Link

    Set Pr.79 (Operation mode) setting value to "0", "2", or "6", Pr.340 (Communication startup mode selection) other than the setting value, Pr.542 (Station num... More Details >>

    • No：21896
    • Release Date：2018/08/22 16:29

  • CC-Link

    Check if the CC-Link wires are short-circuited and/or station numbers are duplicated.　　 More Details >>

    • No：21891
    • Release Date：2018/08/22 16:29

  • NET mode

    After setting Pr.340 to "10", you need to power OFF then ON the inverter to make the new setting enabled because you are setting the operation upon power-on.... More Details >>

    • No：21759
    • Release Date：2018/08/22 16:29

  • CC-Link

    Purchase the FR-A7NC if you are using the option with the FR-A700 or FR-F700P (F700).Purchase the FR-A7NC E kit if you are using the option with the FR-E700. More Details >>

    • No：21902
    • Release Date：2018/08/22 16:30

  • Switching External operation, PU operation

    Setting Pr.79 (Operation mode) to "6" sets the switchover mode. Pressing the "PU/EXT" key on the operation panel during External operation switches the mode ... More Details >>

    • No：21289
    • Release Date：2018/08/22 16:26

  • CC-Link

    1. It depends on how Pr.338 (Communication operation command source) and Pr.339 (Communication speed command source) are set.2. The external terminal reset i... More Details >>

    • No：21838
    • Release Date：2018/08/22 16:29

  • CC-Link

    To set the frequency via CC-Link communication, the NET mode should be selected. The new parameter setting is applied after powering OFF and then ON the inve... More Details >>

    • No：21763
    • Release Date：2018/08/22 16:29

241-250 of Total 295

Inquiries

Contact Us

page top