Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-F700PJ ]

1-10 of Total 252

prev 1 / 26page next

  • Rotation speed display

    It is not switched. The frequency at the fault saved in the faults history is always displayed in frequency [Hz]. More Details >>

    • No：21180
    • Release Date：2018/08/22 16:26

  • Driving a single-phase motor

    No, it cannot. More Details >>

    • No：21253
    • Release Date：2018/08/22 16:26

  • Number of stations that can be set in FR Configurator

    The station numbers that can be set differ depending on the version of FR-Configurator (FR-SW3-SETUP-WJ) setup software. For Ver.2.00 or later, station numbe... More Details >>

    • No：21305
    • Release Date：2018/08/22 16:26

  • Brake resistor

    Connect the brake resistor to the terminal P and terminal PR. (For the FR-A700-7.5K or lower, remove the jumper of the terminals PR and PX.) Do not remove th... More Details >>

    • No：21333
    • Release Date：2018/08/22 16:27

  • FR-PA07

    Specific settings are not required, however, when replacing the FR-E500, check that Pr.146 (Built-in potentiometer switchover) is not set to "0". If it is "0... More Details >>

    • No：21363
    • Release Date：2018/08/22 16:27

  • FR-PA07

    Operations cannot be enabled separately. You only can disable or enable all the operations. More Details >>

    • No：21366
    • Release Date：2018/08/22 16:27

  • A7AY

    1. Yes. 　2. The standard set by Pr.56. More Details >>

    • No：21669
    • Release Date：2018/08/22 16:28

  • Motor with an attached brake

    Connecting it causes no problem. More Details >>

    • No：21671
    • Release Date：2018/08/22 16:28

  • Network operation

    Yes. With the setting "66", you can choose NET operation when X66 is ON, and external operation when X66 is OFF. More Details >>

    • No：21675
    • Release Date：2018/08/22 16:28

  • Terminal

    Change Pr.126 (Terminal 4 frequency setting gain frequency). More Details >>

    • No：21677
    • Release Date：2018/08/22 16:28

1-10 of Total 252

Inquiries

Contact Us

page top