Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-F700PJ ]

201-210 of Total 251

prev 21 / 26page next

  • Auto tuning

    With the monitor indicator "1", there is no problem with the parameter setting of auto tuning. Check if the terminals MRS and SD are not shortened in the wir... More Details >>

    • No：21294
    • Release Date：2018/08/22 16:26

  • Operation panel (DU04)

    The FR-DU04 can be used in the 700 series inverters, however, some restrictions apply and parameter copy is disabled. More Details >>

    • No：21261
    • Release Date：2018/08/22 16:26

  • Base frequency setting value

    Set the rated frequency of the motor used to it.　 More Details >>

    • No：21814
    • Release Date：2018/08/22 16:29

  • Output current value

    The detection level of the output current value cannot be changed using a potentiometer or a similar device.　　 More Details >>

    • No：21779
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Pr.1 (Maximum frequency) or Pr.18 (High speed maximum frequency).　　 More Details >>

    • No：21805
    • Release Date：2018/08/22 16:29

  • Terminal

    Change Pr.126 (Terminal 4 frequency setting gain frequency). More Details >>

    • No：21677
    • Release Date：2018/08/22 16:28

  • FR-DU07

    The FR-DU07 cannot be used with the FR-E700, FR-D700, or FR-F700PJ. More Details >>

    • No：21854
    • Release Date：2018/08/22 16:29

  • Operation stop, frequency setting

    Set Pr.79 (Operation mode) to "1" (PU operation mode).　 More Details >>

    • No：21819
    • Release Date：2018/08/22 16:29

  • 10 VDC voltage from terminal 10

    Setting Pr.73 to "0" does not generate 10 VDC output.The inverter itself only has 5 V at the terminal 10.Setting this parameter to "0" allows 10 V input betw... More Details >>

    • No：21727
    • Release Date：2018/08/22 16:29

  • Parameter setting

    Check if Pr.13 (Starting frequency) is set to higher than 10 Hz.Also check if a signal is input through the terminal MRS. More Details >>

    • No：21722
    • Release Date：2018/08/22 16:29

201-210 of Total 251

Inquiries

Contact Us

page top