Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A024 ]

21-30 of Total 40

prev 3 / 4page next

  • Countermeasure against error

    The inverter alarm "OV3" occurs when the main circuit DC voltage inside the inverter goes higher than the preset value due to the regenerative power returned... More Details >>

    • No：21438
    • Release Date：2018/08/22 16:27

  • FR-A024

    Pr.59 is available in the products manufactured in October 1995 or later. Therefore, it cannot be read from the products manufactured before October 1995. More Details >>

    • No：21170
    • Release Date：2018/08/22 16:26

  • Installation of new serial communication unit FR-CU03

    Remove the parameter unit FR-PU03 and install there. (The installation dimensions of the FR-CU03 are the same as the FR-PU.) You can read and write parameter... More Details >>

    • No：21617
    • Release Date：2018/08/22 16:28

  • Do noise and leakage current increase?

    During non-low-noise operation (initial setting) with the carrier frequency of 1 kHz, both noise and leakage current levels are almost same as the Z024 serie... More Details >>

    • No：21606
    • Release Date：2018/08/22 16:28

  • Part selection

    1. Choose the circuit breaker based on the inverter capacity. 2. Also, choose the brake resistor based on the inverter capacity. 3. Choose the AC reactor bas... More Details >>

    • No：21425
    • Release Date：2018/08/22 16:27

  • Speed control range

    Many geared motors cannot continuously operate at low speed (for example, slower than 6 Hz) due to grease viscosity.If the motor you are using is of this typ... More Details >>

    • No：22028
    • Release Date：2018/08/22 16:30

  • How much low-speed torque can be output?

    By choosing the General-purpose magnetic flux vector control and slip compensation function, you can output torque of 150% or more at 1 Hz (200% or more at 3... More Details >>

    • No：21618
    • Release Date：2018/08/22 16:28

  • How many inverters can I connect using the communication unit?

    Since the communication unit conforms to the EIA Standard RS-485, up to 32 inverters can be connected. (Transmission format: Multidrop link, total wiring len... More Details >>

    • No：21616
    • Release Date：2018/08/22 16:28

  • Model configuration

    The following seven models are available for the 200 V class: 0.1K, 0.2K, 0.4K, 0.75K, 1.5K, 2.2K, and 3.7K The following five models are available for the 4... More Details >>

    • No：21621
    • Release Date：2018/08/22 16:28

  • Can I use the parameter unit FR-PU02?

    Yes, but functions are partially limited. (The FR-PU02 cannot demonstrate its full ability. The FR-PU01 cannot be used.) To use the parameter unit FR-PU02, u... More Details >>

    • No：21613
    • Release Date：2018/08/22 16:28

21-30 of Total 40

Inquiries

Contact Us

page top