Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A024 ]

1-10 of Total 40

prev 1 / 4page next

  • Can I use the parameter unit FR-PU02?

    Yes, but functions are partially limited. (The FR-PU02 cannot demonstrate its full ability. The FR-PU01 cannot be used.) To use the parameter unit FR-PU02, u... More Details >>

    • No：21613
    • Release Date：2018/08/22 16:28

  • Installation of new serial communication unit FR-CU03

    Remove the parameter unit FR-PU03 and install there. (The installation dimensions of the FR-CU03 are the same as the FR-PU.) You can read and write parameter... More Details >>

    • No：21617
    • Release Date：2018/08/22 16:28

  • Range of carrier frequency

    You can vary the carrier frequency within the range of 0.7 to 14.5 kHz, and it is initially set to 1 kHz that generates low noise and leakage current. You ca... More Details >>

    • No：21607
    • Release Date：2018/08/22 16:28

  • Countermeasure against error

    The inverter alarm "OV3" occurs when the main circuit DC voltage inside the inverter goes higher than the preset value due to the regenerative power returned... More Details >>

    • No：21438
    • Release Date：2018/08/22 16:27

  • Fault display

    "E.OV3" is displayed when the voltage between the inverter terminals PN rises abnormally high while the inverter is decelerating or stopped. In this case, th... More Details >>

    • No：21411
    • Release Date：2018/08/22 16:27

  • General-purpose magnetic flux control

    Almost same control method. This control also performs vector calculation and divides the inverter's output current into an excitation current and into a tor... More Details >>

    • No：21620
    • Release Date：2018/08/22 16:28

  • Do noise and leakage current increase?

    During non-low-noise operation (initial setting) with the carrier frequency of 1 kHz, both noise and leakage current levels are almost same as the Z024 serie... More Details >>

    • No：21606
    • Release Date：2018/08/22 16:28

  • Thermal protection

    Providing thermal protection is better for your safety. When the brake transistor explodes, the brake transistor alarm (E.BE) is output. Consider a counterme... More Details >>

    • No：21397
    • Release Date：2018/08/22 16:27

  • Parameter unit FR-PU03

    You can use it with the FR-A200 (E) and FR-A100 (E) series. (Note) Use the connection cable (option). You cannot use it with the FR-Z and FR-U series (except... More Details >>

    • No：21615
    • Release Date：2018/08/22 16:28

  • Synchronous operation of two motors

    When synchronously operating two motors, you need to detect speed from both motors. Each inverter is controlled based on this speed detection signal. As an e... More Details >>

    • No：21540
    • Release Date：2018/08/22 16:28

1-10 of Total 40

Inquiries

Contact Us

page top