Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E500 ]

1-10 of Total 85

prev 1 / 9page next

  • Monitor

    The output current monitor of the inverter displays the output current effective value of the three phases measured by the current sensor. It does not displa... More Details >>

    • No：21373
    • Release Date：2018/08/22 16:27

  • Amount of heat generated

    The amount of heat generated by the FR-E500 series inverter is registered in the Mitsubishi Electric FA Global Website Member's page. Refer to the technical ... More Details >>

    • No：21382
    • Release Date：2018/08/22 16:27

  • Detection of the motor load

    An inverter is used to rotate a motor but it cannot be used to detect whether the belt is broken or not. However, the magnitude of the load will change when ... More Details >>

    • No：21387
    • Release Date：2018/08/22 16:27

  • Countermeasures when input power supply is turned off upon equipment fault

    1. When the inverter power supply is turned OFF, the inverter is disconnected from the CC-Link network. However, since the CC-Link master station has the aut... More Details >>

    • No：21390
    • Release Date：2018/08/22 16:27

  • Driving 200 V motor by 400 V inverter

    Your suggested use is not recommended due to the following reasons: Output voltage of the 400 V inverter contains "micro surge". Usually this surge voltage i... More Details >>

    • No：21403
    • Release Date：2018/08/22 16:27

  • Notes on using single-phase 200 V

    With the single-phase 200 V input specifications, the input cable current increases. Therefore, choose larger power supply capacity and NF/MC than three-phas... More Details >>

    • No：21406
    • Release Date：2018/08/22 16:27

  • Direct driven start by power supply

    The warning "Do not use a magnetic contactor on the inverter input for frequent starting/stopping of the inverter." is indicated in the precautions at the be... More Details >>

    • No：21458
    • Release Date：2018/08/22 16:27

  • Items controllable via CC-Link

    1. Not all items can be controlled. 　　- Functions that cannot be controlled JOG, AU, CS, OH, X10, X11, X12, and X16 functions (Other functions can be control... More Details >>

    • No：21459
    • Release Date：2018/08/22 16:27

  • I want to shorten deceleration time of small capacity motor

    You can use an inverter with a larger capacity than the motor. You cannot connect a brake resistor to the FR-E520-0.1K and 0.2K. With the FR-E520-0.1K or 0.2... More Details >>

    • No：21463
    • Release Date：2018/08/22 16:27

  • Indication of FR-E520

    "PS" appears when the STOP key on the operation panel is pressed during external operation. It is considered that someone pressed the key. Dismiss "PS" in on... More Details >>

    • No：21478
    • Release Date：2018/08/22 16:27

1-10 of Total 85

Inquiries

Contact Us

page top