Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E500 ]

1-10 of Total 84

prev 1 / 9page next

  • Selection of high-duty brake resistor

    Select the high-duty brake resistor according to the inverter capacity. More Details >>

    • No：21953
    • Release Date：2018/08/22 16:30

  • Operation command terminal switching

    It rotates in the forward direction while STF is ON.And then, when STR is turned ON and STF is turned OFF, the inverter decelerates down to 0 Hz within the s... More Details >>

    • No：22070
    • Release Date：2018/08/22 16:30

  • Parameter setting for FR-E500

    General-purpose magnetic flux vector control is effective at low speed under a heavy load.To shorten the acceleration time, use Pr.44 to set the second accel... More Details >>

    • No：22059
    • Release Date：2018/08/22 16:30

  • Inverter

    You can use the Hioki Memory HiCorder and clamp-on AC/DC high tester.You can observe the inverter's frequency in one of the following two methods:1. Attach t... More Details >>

    • No：22082
    • Release Date：2018/08/22 16:30

  • Connection with personal computer

    Connection method for the A500 and E500 is shown in the figure below. The figure is given in an Excel file. Figure 1 More Details >>

    • No：21536
    • Release Date：2018/08/22 16:28

  • Communication operation with FR-E500

    We have no sample program for RS485 communication. Since the communication method of the FR-SW0-SETUP uses a different protocol from 485 communication and st... More Details >>

    • No：21451
    • Release Date：2018/08/22 16:27

  • "Err" is displayed when STF signal turns ON

    Possible causes are:1. The reset signal (RES) is ON. 2. The built-in CPU is not working properly due to contact faults of the inverter parts. Check the exte... More Details >>

    • No：21484
    • Release Date：2018/08/22 16:27

  • Speed 2 operation with potentiometer on operation panel

    Yes. Set parameters as below.For FR-E500Set Pr.79 =3, and Pr.146= 0.Multi-speed is prioritized.For FR-S500Set Pr.79 = 3, and Pr.53 = 1.Multi-speed is priorit... More Details >>

    • No：21963
    • Release Date：2018/08/22 16:30

  • Speed 15 operation

    Using the inverter's input terminal, you can use up to 15 speeds.This function is supported by the current 500 series products (A500, F500, E500, and S500).U... More Details >>

    • No：21947
    • Release Date：2018/08/22 16:30

  • Direct driven start by power supply

    The warning "Do not use a magnetic contactor on the inverter input for frequent starting/stopping of the inverter." is indicated in the precautions at the be... More Details >>

    • No：21458
    • Release Date：2018/08/22 16:27

1-10 of Total 84

Inquiries

Contact Us

page top