Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E500 ]

11-20 of Total 84

prev 2 / 9page next

  • I want to synchronize the Z200 and E500.

    If you are using analog voltage commands, connect the voltage inputs to the FR-E500 and FR-Z200 in parallel to equalize inputs to both units and speeds are s... More Details >>

    • No：21929
    • Release Date：2018/08/22 16:30

  • Using built-in potentiometer and multi-speed together

    Yes. Set Pr.79 = 3. (Input the start signal from an external source.) More Details >>

    • No：21950
    • Release Date：2018/08/22 16:30

  • Operation frequency

    I cannot answer clearly because the load is unknown. The operation cycle of operating for 10 seconds and stopping for 10 seconds is OK, but it is questionabl... More Details >>

    • No：21474
    • Release Date：2018/08/22 16:27

  • CC-Link

    Although you specify the FR-V200 and others as the inverter models, CC-Link is currently supported by the FR-A500 and FR-E500. The FR-V200E does not support ... More Details >>

    • No：21499
    • Release Date：2018/08/22 16:27

  • Frequency setting

    Ensure that the inverter is in the PU operation mode and stopped, change the following parameters: 1. Read Pr.923 (Built-in frequency setting potentiometer g... More Details >>

    • No：21416
    • Release Date：2018/08/22 16:27

  • Parameters not covered in manual are displayed

    Pr.168 indicates the inverter software version.Pr.169 indicates the inverter software subversion history. These two parameters are only used by the manufactu... More Details >>

    • No：21532
    • Release Date：2018/08/22 16:28

  • Built-in potentiometer and current input switching control

    For setting the frequency, you cannot switch between the operation panel potentiometer and current input from an external source.To switch between the extern... More Details >>

    • No：21985
    • Release Date：2018/08/22 16:30

  • Relationship between frequency and output torque

    The output torque characteristics of the FREQROL-E500 series are shown in the figure below. Figure 1 More Details >>

    • No：22024
    • Release Date：2018/08/22 16:30

  • Comparison with E500

    The major differences are:- Capacity range- Availability of regenerative brake resistor- Operation of the operation panel- Number of I/O terminals More Details >>

    • No：22056
    • Release Date：2018/08/22 16:30

  • Monitor

    The output current monitor of the inverter displays the output current effective value of the three phases measured by the current sensor. It does not displa... More Details >>

    • No：21373
    • Release Date：2018/08/22 16:27

11-20 of Total 84

Inquiries

Contact Us

page top