Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E500 ]

81-85 of Total 85

prev 9 / 9page next

  • Noise from motor at low speed

    It is considered to be caused by inverter PWM control. It can be suppressed by raising the PWM carrier frequency (Pr.72), but the entire noise and leakage cu... More Details >>

    • No：21428
    • Release Date：2018/08/22 16:27

  • Err display on operation panel

    The following causes are probable for this Err display:- Operation error (for example, you tried to input a value other than the available range of parameter... More Details >>

    • No：22063
    • Release Date：2018/08/22 16:30

  • Parameter No.79 (Operation mode)

    You cannot cancel multi-speed command input. When the multi-speed command is input from the terminal, you cannot use the potentiometer. Use the inverter so t... More Details >>

    • No：21467
    • Release Date：2018/08/22 16:27

  • Deceleration overvoltage (E.OV3)

    While the FREQROL-Z200 series and A500 series have a brake resistor built in the capacity up to 7.5K, the FREQROL-E500 series does not have a built-in brake ... More Details >>

    • No：21993
    • Release Date：2018/08/22 16:30

  • Error E.LF

    Measure the megger values on the inverter's output side.If there is no problem:If the motor capacity is extremely smaller than the inverter capacity (as a gu... More Details >>

    • No：21933
    • Release Date：2018/08/22 16:30

81-85 of Total 85

Inquiries

Contact Us

page top