Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

FAQ within [ FREQROL-E500 ]

1-10 of Total 85

prev 1 / 9page next
  • Output specification between FM and SD

    The output signal across FM and SD is pulse output. The output frequency and number of pulses of the output signal across FM and SD are proportional. However... More Details >>

    • No:21384
    • Release Date:2018/08/22 16:27
  • Amount of heat generated

    The amount of heat generated by the FR-E500 series inverter is registered in the Mitsubishi Electric FA Global Website Member's page. Refer to the technical ... More Details >>

    • No:21382
    • Release Date:2018/08/22 16:27
  • CC-Link monitor and parameter setting

    1. Since you can monitor the output frequency independently, you do not need to switch monitoring by the monitor commands. Assign the remote register RWr0 to... More Details >>

    • No:21418
    • Release Date:2018/08/22 16:27
  • Indication of FR-E520

    "PS" appears when the STOP key on the operation panel is pressed during external operation. It is considered that someone pressed the key. Dismiss "PS" in on... More Details >>

    • No:21478
    • Release Date:2018/08/22 16:27
  • I want to shorten deceleration time of small capacity motor

    You can use an inverter with a larger capacity than the motor. You cannot connect a brake resistor to the FR-E520-0.1K and 0.2K. With the FR-E520-0.1K or 0.2... More Details >>

    • No:21463
    • Release Date:2018/08/22 16:27
  • Connecting operation panel to enclosure

    To connect the operation panel to the enclosure, use the parameter unit connection cable FR-CB201, FR-CB203, or FR-CB205. The maximum cable length is 5 m. No... More Details >>

    • No:21542
    • Release Date:2018/08/22 16:28
  • CC-Link

    Already released.Unlike the E520, you need to purchase the optional card FR-E5NC. More Details >>

    • No:22050
    • Release Date:2018/08/22 16:30
  • Inverter general matters

    1. To perform emergency stop, it is recommended to have the motor coast and stop it using a mechanical brake.In this case, the output stop (MRS) signal is in... More Details >>

    • No:22103
    • Release Date:2018/08/22 16:31
  • Control method

    1. Can I set the frequency by the external potentiometer when multi-speed signal is 0 (nothing is input)?-> It is possible by using the external operation... More Details >>

    • No:21990
    • Release Date:2018/08/22 16:30
  • Alarm output signal when using CC-Link

    The RX7 output signal is the same as the signals for NO, NC, and transfer contact output.You can change the contents of this output signal using Pr.192.Pr.19... More Details >>

    • No:22008
    • Release Date:2018/08/22 16:30

1-10 of Total 85

Inquiries