Terminating resistors for CC-Link communication

There are two types of terminating resistors for CC-Link communication. Both two types are packaged with a CC-Link master/local module. (1) 110 ohm, 1/2W (B... More Details >>

Update timing of LD75 current feed value and machine feed value

The values are updated at the timing described below. - Current feed value: 0.9 ms - Machine feed value: 0.9 ms More Details >>

Behavior of sequence program in event of momentary power failure in QCPU

(1) When a momentary power failure occurs for a period not longer than the allowable momentary power failure time When the momentary power failure occurs, t... More Details >>

USB driver installation procedure

For the USB driver installation procedure, refer to the following manuals.- GX Developer Version 8 Operating Manual (Startup) Chapter 3- GX Works2 Version 1 ... More Details >>

MELSOFT connection of the FX3U-ENET-L Ethernet interface block

Up to 2 connections can be opened. More Details >>

Setting for sequentially inputting device comments in GX Works2

Select [Tool]-> [Options]-> [Program Editor] -> [Ladder/SFC] -> [Enter ladder] from the menu, and set [Enter label comment and device comment]... More Details >>

L60DA4 accuracy

- Ambient temperature: 25+/-5degrees Celsius with tolerance of +/-0.1% - Ambient temperature: 0 to 55degrees Celsius with tolerance of +/-0.3% (accuracy f... More Details >>

GX Works2's compatibility with the A series modules

GX Developer is automatically launched when A series is selected as a new project in GX Works2.For the A series modules, use GX Developer. More Details >>

Positioning start

There are two ways to start a positioning operation: (1) Set the "[Cd.3] Positioning start No.", and turn ON the positioning start signal. (2) Use the dedica... More Details >>

Torque limit

Torque is limited by the lower set value of "[Pr.17] Torque limit setting value" and "[Cd.22] New torque value".When the current torque reaches the limit, "b... More Details >>