Positioning blocks/module that can be connected with a manual pulse generator

The FX3U-20SSC-H (differential line driver), FX2N-10PG (differential line driver or open collector: only 5 V type), and FX2N-10GM/FX2N-20GM (open collector) ... More Details >>

Cause to turn on the ERR LED of a CC-Link master module

All stations communication error of a slave station.When POWER of the slave station is off, check if 24 V DC has been supplied.When POWER is on, check the st... More Details >>

Duplication error in a CC-Link master station

Possible causes are as follows.(1) Another master station exists on the same line.(2) Noise is detected on the line at power on. More Details >>

Settings required for transient transmission

The routing parameter settings are required for transient transmission to the CPU module with another network No. The request source station, relay station,... More Details >>

List of registers assigned to the labels set using GX Works2

To display a list of registers assigned to labels, check [Find Label Definition] and [Display all items] in the [Condition Setting] tab in the [Cross Refere... More Details >>

Memory allocation for online change in GX Developer

Select [Online] -> [Write to PLC] on the menu of GX Developer, open the [File selection] tab, and press "Param + Prog" button. Then open the [Program] ta... More Details >>

Specifying the number of digits in the Structured Text

For actual bit devices, the number of digits can be specified. For labels, the number of digits cannot be specified. More Details >>

Regarding support for the FX5-EIP Auto refresh function

The Auto refresh function is supported. More Details >>

MX Component Version 4's compatibility with the L series CPU

MX Component Version 4 supports the L series CPU. More Details >>

Regarding the MQTT Communication Function Publish Program

You can't program it with the ladder program alone. To use the MQTT communication and email functions, you must use the module FB and program it. More Details >>