Availability of step ladders for FX in L series

Step ladders are not available in LCPU. There is no alternative function. More Details >>

Link register assignments in MELSECNET/10 networks

For any type of MELSECNET network (II, /10, and H), B and W devices with the same number cannot be used for multiple stations as write areas. Following th... More Details >>

Read and write operations for CC-Link buffer memory

There is no problem in writing/reading data into/from the buffer memory using a FROM/TO instruction with the refresh device setting left blank.The refresh de... More Details >>

SLD and FG wiring for CC-Link networks

Ground FG in each station. SLD and FG are internally short-circuited. More Details >>

Setting required to skip CC-Link slave station numbers

A CC-Link slave station number can be skipped by assigning the skipped number to a reserved station. A reserved station is counted as one of all the connecte... More Details >>

32-bit data assurance

To assure 32-bit data, "Network Range Assignment" of the control station must satisfy the following conditions.(1) The start device No. of LB is a multiple o... More Details >>

How to use built-in high-speed counters

For contacts to drive the coils of high-speed counters, use the contacts which are normally on during high-speed counting. Do not use the input (X000 to X00... More Details >>

MELSOFT connection of the FX3U-ENET-L Ethernet interface block

Up to 2 connections can be opened. More Details >>

Drive products (servo amplifiers) that can be connected to the FX3U-1PG pulse output block

Servo amplifiers, such as MR-J4-□A and MR-JN-□A, that support pulse train input can be connected. For connectable drive products, such as servo amplifiers, ... More Details >>

Output frequency of the FX3U-1PG pulse output block

It is from 1 Hz to 200 kHz. More Details >>