Parameter settings for a CC-Link master station and local stations

Local stations also need parameter settings. More Details >>

Connecting terminating resistors to the sending end and the receiving end in communication of QJ71C24N

Yes. More Details >>

CC-Link master module settings

If each master module controls their own CC-Link networks, all master modules can be set as station 0 even though they are controlled by the same CPU. More Details >>

How to check link errors in CC-Link slave stations

The data link status is stored in SW80 to SW83.Each bit corresponds to a station number and a bit turns ON if the corresponding station causes a data link er... More Details >>

CC-Link IE Controller cable standard

Use the cables that meet the IEC60793-2-10 Types A1a.1 optical fiber standard. The connectors are LC (duplex) connectors. Two cores are required.The core di... More Details >>

Links with a CC-Link local station cannot be made

Check the following points. (1) CC-Link cables have been properly connected. (2) Station numbers and the transmission speed have been correctly set. (3)... More Details >>

Communication between CPU modules established by QJ71E71

The communication between QJ71E71 series modules can be established if READ/WRITE instructions are used. More Details >>

Order in which a CC-Link master module and slave stations are connected

There is no restriction on the positions of a master station and slave stations where they are connected. (Stations are not required to be connected in order... More Details >>

Applicable size for plug-in connector socket block on QJ71C24N-R4

Use the plate terminal packaged with the module. The size of the plate terminal is 1.0 mm wide with a thickness of 0.8 mm. More Details >>

Connecting terminating resistors for CC-Link communication

Connect terminating resistors to both ends of physical cables.A master station is not necessarily required to be connected to either end of its network. More Details >>