Unit of receive data used by the QJ71C24N series pre-defined protocol support function

The fixed data is used for specific codes and character strings such as a command. Setting a device is not required. More Details >>

Parameter setting of CC-Link IE Field Network

No, you do not have to set the network range assignment parameters for slave stations. By setting the network range assignment parameters for a master statio... More Details >>

How to check errors in a CC-Link master station

When an error has occurred in the master station (including the standby master station), the data link control cannot be performed, and you cannot check erro... More Details >>

SB/SW refresh device setting with CC-Link

There are no problems even though the SB/SW refresh device has not been set. More Details >>

SB/SW refresh device setting with CC-Link

SB/SW uses 512 points of refresh devices. More Details >>

Using a fixed latched (battery backed) type device as a general type device

Clear the required area with the ZRST instruction by using the initial pulse when the programmable controller is set to RUN. To clear all the latched type de... More Details >>

Overwriting a current value with the high-speed counter comparison instruction

The output contact is activated according to the change of the current value register along with the counting input. Therefore, the value changed by executin... More Details >>

Output numbers of the FX programmable controllers

Since they are octal, the number after Y7 is Y10 and after Y77 is Y100. More Details >>

Terminal layout on the output side of the FX3U-16MR/ES

Yes, they are independent common terminals. More Details >>

Switching network between 10BASE-T and 100BASE-TX of the FX3U-ENET-L

It cannot be freely switched. It is automatically switched according to the auto detection function. More Details >>