Difference between AJ65SBTB1-16DT1 and AJ65SBTB1-16DT2

Major differences are shown below. - AJ65SBTB1-16DT1 - Rated input current approx. 5 mA - ON voltage/ON current 15 VDC or higher/3.0 mA or higher - O... More Details >>

Terminating resistors for QJ71C24N

A terminating resistor must be connected to the interface in order to reduce signal reflections thus preventing the signal instabilities. More Details >>

CC-Link master modules' start I/O No. and refresh devices RX/RY

The I/O numbers used for I/O modules and intelligent function modules cannot be used as refresh targets for RX/RY. Use the I/O numbers greater than those use... More Details >>

Detecting the number of disconnections when using QJ71E71-100

The number of disconnections detected can be checked by reading the buffer memory address 5203H (Disconnection detection count). Disconnections are detected ... More Details >>

Whether or not multiple QJ72LP25-25 modules can be mounted

No, only a single QJ72LP25-25 can be mounted (and is to be mounted on the CPU slot on a main base unit). More Details >>

CD terminal setting of the QJ71C24N

"The CD terminal is not checked" has been set by default. More Details >>

Grounding of CC-Link

The functional grounding is applied to ensure the reliability of the communication. More Details >>

SB/SW refresh device setting with CC-Link

SB/SW uses 512 points of refresh devices. More Details >>

Pulse output type of the FX3U-1PG pulse output block

It is transistor output. Transistor output specifications are as follows. ･ Rated load voltage 5 to 24 V DC ･ Maximum load current 20 mA or lower More Details >>

Regarding CC-Link IE TSN CANopen Communication function

The CANopen communication functions supported by the FX5-CCLGN-MS conform to the CiA402 CANopen profile, and can control devices that support the CiA402 devi... More Details >>