Whether or not totem pole output type encoders are connected

Totem pole output encoders cannot be connected to QD62.The following types of encoders can be connected.- Open collector output type encoders- CMOS level vol... More Details >>

Speeds of access to file registers

If file registers are registered in the standard RAM and "R" is specified by an instruction, the processing time is the same as is the case with the internal... More Details >>

How to launch GX Works2 or other tools after installing iQ Works

The tools can be launched individually. More Details >>

Boot file setting of the QnUDVCPU

No. You cannot use an SRAM card, ATA card, or Flash card. Specify an SD memory card as the transfer source (boot source). More Details >>

How to control MV value

You can use the output change upper limit value and the MV upper/lower limit limiter, the functions common to each PID control tag. Set the following parame... More Details >>

Writing files in CSV format

Use SP.FWRITE instruction to save the data to an SD memory card in CSV format. More Details >>

Use of an A-compatible 1E frame for the built-in Ethernet port of LCPU

The built-in Ethernet port in the L series is compatible only with a QnA-compatible 3E frame of the MC protocol. An A-compatible 1E frame is not supported. More Details >>

Behavior of sequence program in event of momentary power failure in LCPU

(1) When it happened no longer than the allowable momentary power failure time. The module records an error log and suspends the operation processing. Ho... More Details >>

Simultaneous broadcast reception setting for built-in Ethernet port LCPU

To receive simultaneous broadcast using UDP, set the parameters as follows. - Destination IP Address: FF.FF.FF.FFh - Destination Port No.: Other than FFFFh (... More Details >>

CSV file storage timing in L series logging function

No. More Details >>