Open setting of the built-in Ethernet port QCPU

No.It is necessary to configure one port to use the MELSOFT connection. More Details >>

Parameter settings required to use the MODBUS(R) interface module as a slave station

If preset initial values are used, parameters do not need setting.If changing the basic parameter or MODBUS(R) device assignment parameter, use a sequence pr... More Details >>

How to check the capacity of the file registers in use

The capacity file registers currently have can be checked in the file register setting section ([PLC Parameter] -> [PLC File] tab). More Details >>

How to control MV value

You can use the output change upper limit value and the MV upper/lower limit limiter, the functions common to each PID control tag. Set the following parame... More Details >>

How to use L series extension modules

The extension module is used to configure the extension block when 10 modules or more are mounted to LCPU. Connect the branch module and the extension module... More Details >>

Loop disconnection detection function and heater disconnection detection function of temperature control module

The heater disconnection detection function monitors the heater current on the transistor output. If no current flows when the transistor is ON, it is consi... More Details >>

END cover

An error occurs and CPU will stop. Install the END cover and reset the CPU module. More Details >>

L60TCRT4(BW) accuracy

- Ambient temperature: 25+/-5degrees Celsius Full scalex (+/-0.3%) - Ambient temperature: 0 to 55degrees Celsius Full scalex (+/-0.7%) More Details >>

Continuous logging

Yes. As a guide, the processing time is shown below.For the logging condition, refer to figure 1 below. - For 16 devices: 2 ms - For 64 devices: 6 ms More Details >>

MX Sheet Version 2's compatibility with 64-bit Windows 7

Yes. More Details >>