Drive products (servo amplifiers) that can be connected to the FX3U-1PG pulse output block

Servo amplifiers, such as MR-J4-□A and MR-JN-□A, that support pulse train input can be connected. For connectable drive products, such as servo amplifiers, ... More Details >>

Cable provided with the FX2N series extension unit

It is available as a repair part. Please consult with localMitsubishi Electric representative. More Details >>

Support of the DHCP (Dynamic Host Configuration Protocol) function by the FX3U-ENET-ADP (for Ethernet communications)

The FX3U-ENET-ADP does not support the DHCP function. Set the fixed IP address using the parameter setting of GX Works2. On GX Works2, select "Parameter" and... More Details >>

Data that can be stored in a memory cassette (FX3U/FX3UC)

The device memory data cannot be stored in a memory cassette. In the FX3U/FX3UC series, a part of device memory data can be latched using a battery. The de... More Details >>

Writing a program to a memory cassette

A memory cassette has a PROTECT switch to prevent a program from being overwritten in EEPROM and flash ROM. When this switch is on, writing of the program i... More Details >>

SB/SW refresh device setting with CC-Link

SB/SW uses 512 points of refresh devices. More Details >>

CC-Link signals checked when an error occurs

Check the following signals.- Module error signal : X0- Host data link status signal: X1- Other station data link status signal: X3 More Details >>

Connecting terminating resistors to the sending end and the receiving end in communication of QJ71C24N

Yes. More Details >>

CC-Link master modules' start I/O No. and refresh devices RX/RY

The I/O numbers used for I/O modules and intelligent function modules cannot be used as refresh targets for RX/RY. Use the I/O numbers greater than those use... More Details >>

Parameter settings for a CC-Link master station and local stations

Local stations also need parameter settings. More Details >>