FX3U-ENET-ADP connectable programmable controllers in the MELSEC-F series

The FX3U-ENET-ADP can be connected to the FX3G/FX3GC series (both Ver. 2.00 or later) and the FX3U/3UC series (both Ver. 3.10 or later). Products which are ... More Details >>

Modules that support differential line driver outputs

The FX3U-2HSY-ADP, FX2N-10PG support differential line driver outputs. More Details >>

SB/SW refresh device setting with CC-Link

SB/SW uses 512 points of refresh devices. More Details >>

Grounding of CC-Link

The functional grounding is applied to ensure the reliability of the communication. More Details >>

Limitation on the number of MELSOFT products that can be connected with the QJ71E71

In the TCP/IP connection, you can connect up to 17 MELSOFT products at the same time using a dedicated connection for system and the connections for users 1 ... More Details >>

Using Ethernet UTP cables for the CC-Link IE Controller

Ethernet UTP cables cannot be used. More Details >>

Precaution about MELSECNET/H connection (2)

- Set the network module mounted in system A to station number 0 (multiplexed remote master station). Set the network module mounted in system B to any sta... More Details >>

32-bit data assurance

To assure 32-bit data, "Network Range Assignment" of the control station must satisfy the following conditions.(1) The start device No. of LB is a multiple o... More Details >>

Applicable size for plug-in connector socket block on QJ71C24N-R4

Use the plate terminal packaged with the module. The size of the plate terminal is 1.0 mm wide with a thickness of 0.8 mm. More Details >>

Receiving data when no receive complete code is designated (QJ71C24N)

Data are received on a received data count basis. If there is no receive complete code and variable length data is received, the data is received at every no... More Details >>