Procedure for developing programs

It is necessary to install a development environment (Tornado or Wind River Workbench) and set parameters using the Setting/monitoring tools for the C Cont... More Details >>

Boot operation from the standard ROM in the universal model QCPU

The universal model QCPU modules have their standard ROM but boot operation from the standard ROM is impossible. Boot the module from a memory card. More Details >>

Label programs in GX Works2

Change the program using the following method.Write the label program to the programmable controller CPU and perform PLC read for the parameters and the prog... More Details >>

Capacity setting of file registers

Set 96K points. (1K point = 1024 points) More Details >>

GX Works2's compatibility with Monitor (write mode)

From version 1.62Q, GX Works2 supports Monitor (write mode). Pressing Shift+F4 allows an online change. More Details >>

Reading file registers simultaneously with the program, parameters, and other data in GX Works2

No. Switch the target memory for PLC Data and read the file registers alone. More Details >>

USB cable type for CPU modules

It is type B. More Details >>

Counting operation of QD62

The corresponding operation depends on the counter type selected. (1) If "Linear Counter" is selected If the present counter value exceeds the upper limi... More Details >>

CPU modules that support the File Register Extended Setting

The universal model QCPU modules other than Q00UJCPU support the File Register Extended Setting. More Details >>

Versions of the QJ71C24N modules compatible with QnUDVCPU

The QJ71C24N series modules with serial numbers with upper 5 digits of "10042" or later indicate compatibility with QnUDVCPU. More Details >>