Simple PLC communication function

This function allows data communications between specified devices at the specified timing, using the built-in Ethernet. Device data such as production data ... More Details >>

Number of points used for I/O assignment of LCPU built-in I/O function

X00 to X0F and Y00 to Y07 are sorted for each function. For more details, refer to "MELSEC-L CPU Module User's Manual (Built-In I/O Function)". More Details >>

Versions of LCPU compatible with LJ71E71-100

The L series CPU serial numbers with upper 5 digits of "14112" or later indicate compatibility with LJ71E71-100. More Details >>

Simultaneous broadcast reception setting for built-in Ethernet port LCPU

To receive simultaneous broadcast using UDP, set the parameters as follows. - Destination IP Address: FF.FF.FF.FFh - Destination Port No.: Other than FFFFh (... More Details >>

Installing MX Component Version 3 and 4

No, please install only either of the two. More Details >>

Opening SFC programs in GX Works2

To open a GX Developer project, select [Project] -> [Open Other Data] -> [Open Other Project] from the menu of GX Works2. More Details >>

Limit on the display of data collected in GX LogViewer to 32 values

GX LogViewer is made to a specification that allows a single trend window to display a maximum of 32 graphs. When there are more than 32 logging data values,... More Details >>

I cannot open a project file of PX Developer.

When the total number of characters in the drive/path and project name exceeds 149 one-byte characters (74 two-byte characters), the message "The drive path ... More Details >>

Necessity of terminating resistors in CC-Link communication

No, it is unnecessary. Terminating resistors are only required at both ends of the network. More Details >>

Difference between AJ65SBTB1-16DT and AJ65SBTB1-16DT1

Major differences in input specifications are shown below. - AJ65SBTB1-16DT - Rated input current approx. 7 mA - ON voltage/ON current 14 VDC or higher/... More Details >>