Assignment of input/output numbers (MELSEC-F series)

Octal numbers are assigned as input/output numbers for the MELSEC-F series. The octal number system uses the digits from 0 to 7 → from 10 to 17 → from 20 to... More Details >>

FL-net setting of GX Works2

You can set the parameters of the FL-net interface module with the data operation of the intelligent function module. For details and operation procedure of... More Details >>

Whether or not multiple QJ72LP25-25 modules can be mounted

No, only a single QJ72LP25-25 can be mounted (and is to be mounted on the CPU slot on a main base unit). More Details >>

Connecting the CC-Link IE Field Network with a personal computer

To pursue high speeds, the CC-Link IE Field Network applies a communication control method different from that applied to the Ethernet communication for pers... More Details >>

Executing the QJ71C24N's pre-defined protocol support function

Executing the CPRTCL instruction (dedicated instruction) executes a specified protocol. More Details >>

Terminating resistors for RS-485 communication of LJ71C24

The resistance value is 110 ohm, 1/2 W. More Details >>

Whether or not MC protocol frames can be used after A1SJ71UC24 is replaced with QJ71C24N

The QJ71C24N series modules can be accessed using A-compatible 1C frames, but the following restrictions are imposed. The access is limited to the devices wi... More Details >>

Precautions taken when QJ61BT11 is replaced with QJ61BT11N

Set the Network Parameter as shown below. (1) If QJ61BT11 is in the remote net mode, use the remote net Ver.1 mode for QJ61BT11N. (2) If QJ61BT11 is in the... More Details >>

MX Component Version 4's compatibility with Visual Studio 2005

Yes. More Details >>

MX Sheet Version 2's compatibility with 32-bit Excel2010

Yes. More Details >>