Applicable size for plug-in connector socket block on QJ71C24N-R4

Use the plate terminal packaged with the module. The size of the plate terminal is 1.0 mm wide with a thickness of 0.8 mm. More Details >>

How to make the expanded cyclic setting for CC-Link local stations

Make the expanded cyclic setting for a CC-Link local station using the programming tool, GX Developer or GX Works2. Follow the procedure below. (1) Set th... More Details >>

Setting required to skip CC-Link slave station numbers

A CC-Link slave station number can be skipped by assigning the skipped number to a reserved station. A reserved station is counted as one of all the connecte... More Details >>

CC-Link master modules' start I/O No. and refresh devices RX/RY

The I/O numbers used for I/O modules and intelligent function modules cannot be used as refresh targets for RX/RY. Use the I/O numbers greater than those use... More Details >>

How to set CC-Link reserved stations

- If the Network Parameter is used Make "Station Information Setting". - If the parameter is set using a dedicated instruction Set the control data of... More Details >>

RS-485 connection between QJ71C24N and an external device

Short between SDA and RDA and between SDB and RDB, and then connect them to + (Data-A) and - (Data-B) on the external device. More Details >>

Writing comments into a programmable controller

Make a space for comments in the parameter setting of the programmable controller with GX Developer.To write the created comments into a programmable control... More Details >>

Programming for FX programmable controllers in ST language

You can create a program with "GX Works2" of MELSOFT applications. More Details >>

GX Developer's compatibility with LJ71E71-100

GX Developer does not support LJ71E71-100. Use GX Works2. More Details >>

Using MX Sheet data

If MX Sheet that supports Excel2010 is installed, the data can be used as they are. More Details >>