Receiving data when no receive complete code is designated (QJ71C24N)

Data are received on a received data count basis. If there is no receive complete code and variable length data is received, the data is received at every no... More Details >>

Links with a CC-Link local station cannot be made

Check the following points. (1) CC-Link cables have been properly connected. (2) Station numbers and the transmission speed have been correctly set. (3)... More Details >>

CC-Link IE Controller cable standard

Use the cables that meet the IEC60793-2-10 Types A1a.1 optical fiber standard. The connectors are LC (duplex) connectors. Two cores are required.The core di... More Details >>

Cables for CC-Link networks

Use CC-Link dedicated cables. General-purpose cables cannot be used. More Details >>

SLD and FG wiring for CC-Link networks

Ground FG in each station. SLD and FG are internally short-circuited. More Details >>

Effect on sequence scans in MELSECNET/H networks

It is necessary to reduce the link refresh time of the MELSECNET/H network in order to reduce the scan time. The link refresh time can be reduced by reducin... More Details >>

Refresh devices

For CPU modules with 8192 I/O device points (X/Y0 to 1FFF), X/Y1000 and greater can be set as refresh devices. More Details >>

Terminating resistors for RS-485 communication of LJ71C24

The resistance value is 110 ohm, 1/2 W. More Details >>

CC-Link master modules' start I/O No. and refresh devices RX/RY

The I/O numbers used for I/O modules and intelligent function modules cannot be used as refresh targets for RX/RY. Use the I/O numbers greater than those use... More Details >>

Settings required for transient transmission

The routing parameter settings are required for transient transmission to the CPU module with another network No. The request source station, relay station,... More Details >>