How to relay CC-Link cables

Use a T-branch repeater module instead of a terminal block. More Details >>

Parameter setting of CC-Link IE Field Network

No, you do not have to set the network range assignment parameters for slave stations. By setting the network range assignment parameters for a master statio... More Details >>

Limitation on the number of MELSOFT products that can be connected with the QJ71E71

In the TCP/IP connection, you can connect up to 17 MELSOFT products at the same time using a dedicated connection for system and the connections for users 1 ... More Details >>

Using Ethernet UTP cables for the CC-Link IE Controller

Ethernet UTP cables cannot be used. More Details >>

Unit of receive data used by the QJ71C24N series pre-defined protocol support function

The fixed data is used for specific codes and character strings such as a command. Setting a device is not required. More Details >>

Connecting terminating resistors for CC-Link communication

Connect terminating resistors to both ends of physical cables.A master station is not necessarily required to be connected to either end of its network. More Details >>

Station number settings for MELSECNET/H networks

A station number can be skipped by setting the station as a reserved station. More Details >>

Terminating resistors for RS-485 communication of LJ71C24

The resistance value is 110 ohm, 1/2 W. More Details >>

Parameter settings for a CC-Link master station and local stations

Local stations also need parameter settings. More Details >>

Difference between AJ65SBTB1-16DT1 and AJ65SBTB1-16DT2

Major differences are shown below. - AJ65SBTB1-16DT1 - Rated input current approx. 5 mA - ON voltage/ON current 15 VDC or higher/3.0 mA or higher - O... More Details >>