Compatibility with 64-bit Windows 7

GX Works2 Version 1.62Q or later supports Windows 7. More Details >>

GX Simulator in GX Works2 disk

The simulation function is included in GX Works2.For more details of the functions of GX Work2, refer to GX Works2 Version 1 Operating Manual (Common). More Details >>

High-speed timer

Follow the procedure below to insert a high-speed timer.- Click the Coil button on the toolbar or press the function key F7, then enter "HT[ ] K[ ]".- Click ... More Details >>

Difference between Q61P and Q64PN

There are differences in 5 VDC rated output current and in 5 VDC overcurrent protection.The difference in 5 VDC rated output current is as follows.- Q61P: 6 ... More Details >>

Combination of the MELSEC iQ-R series inter-module synchronization function and the fixed scan communication of the multiple CPU system function

You can synchronize the fixed scan communication cycle of the multiple CPU system function with the inter-module synchronization cycle of the inter-module s... More Details >>

Regarding Cloud Connectivity

It is possible to connect to the cloud: MQTT broker (server) using the MQTT communication function of FX5-ENET. The MQTT communication function is supported... More Details >>

Connection of expansion boards and a display module to FX3G series main unit

They can be used together. * 14/24-point type FX3G series main unit ･ An expansion board can be connected to BD1 (1st position) and a display module can be... More Details >>

Output numbers of the FX programmable controllers

Since they are octal, the number after Y7 is Y10 and after Y77 is Y100. More Details >>

Comparison result of the CMP instruction

A comparison result is held even after the command input turns off. The remaining comparison result can be cleared by using the RST or ZRST instruction. More Details >>

Relation between CC-Link terminals and signal lines

The following shows the relations between CC-Link terminals and signal lines. - DA : Blue -DB: White -DG: Yellow More Details >>