MX Sheet Version 2's compatibility with 32-bit Excel2010

Yes. More Details >>

Assignment for connecting two CC-Link remote input modules (16-point type) (Remote net Ver.1 mode)

X devices will be assigned as follows. (With this setting, 32 points are occupied per station.) - Station No. 1: X100 to X11F -Station No. 2: X120 to X13... More Details >>

Use of 4E frame for built-in Ethernet port of LCPU

The built-in Ethernet port in the L series is compatible only with the QnA-compatible 3E frame. The 4E frame is not supported. More Details >>

Difference between GX Works2 and GX Works

GX Works2 is programmable controller engineering software integrating programming and simulation of programmable controller and setting monitor tool functio... More Details >>

COMMENT to disappear after a PLC type change

Copy the COMMENT into the MAIN of comments by program before changing the PLC type.The basic model QCPU cannot deal with common comments. More Details >>

How to check automatically assigned devices in GX Works2

Click the local label to be checked and select "Cross Reference" from the right-click menu to check the devices. More Details >>

LCPU parameter number check

Refer to the following manual. MELSEC-L CPU Module User's Manual (Function Explanation, Program Fundamentals) Appendix 1 More Details >>

Connecting QJ71C24N to an external device that has no DTR signal

Carry out DTR and DSR wiring that returns signals on QJ71C24N(-R2). More Details >>

FL-net setting of GX Works2

You can set the parameters of the FL-net interface module with the data operation of the intelligent function module. For details and operation procedure of... More Details >>

Whether or not MC protocol frames can be used after A1SJ71UC24 is replaced with QJ71C24N

The QJ71C24N series modules can be accessed using A-compatible 1C frames, but the following restrictions are imposed. The access is limited to the devices wi... More Details >>