Reading project data from a CD-R

To reopen project data written to a CD-R, copy the project data into a space such as a hard disk on the personal computer where the project data is used.This... More Details >>

Whether or not MC protocol frames can be used after A1SJ71UC24 is replaced with QJ71C24N

The QJ71C24N series modules can be accessed using A-compatible 1C frames, but the following restrictions are imposed. The access is limited to the devices wi... More Details >>

Executing the QJ71C24N's pre-defined protocol support function

Executing the CPRTCL instruction (dedicated instruction) executes a specified protocol. More Details >>

Communication between CPU modules established by QJ71E71

The communication between QJ71E71 series modules can be established if READ/WRITE instructions are used. More Details >>

How to read projects created by GX Works2 in GX Developer

Select [Project] -> [Export to GX Developer Format File] and save the project so that it can be opened in GX Developer.For more details, refer to GX Works... More Details >>

Program by program difference in comments on display

There are two types of device comments: "global device comment" and "local device comment". Device comments can be displayed in the ladder editor and Zoom... More Details >>

GX Works2's compatibility with the ACPU modules

GX Works2 does not support the ACPU modules.Use GX Developer for the ACPU modules.GX Developer is included on the CD-ROM of GX Works2.For the installation pr... More Details >>

SLD and FG wiring for CC-Link networks

Ground FG in each station. SLD and FG are internally short-circuited. More Details >>

CD terminal setting of the QJ71C24N

"The CD terminal is not checked" has been set by default. More Details >>

Assignment for connecting two CC-Link remote input modules (16-point type) (Remote net Ver.1 mode)

X devices will be assigned as follows. (With this setting, 32 points are occupied per station.) - Station No. 1: X100 to X11F -Station No. 2: X120 to X13... More Details >>