Differences between the AJ65SBTB1-16T...
The following shows the major differences. -AJ65SBTB1-16TE - 1-wire terminal block, 1-common type - Maximum load current: 0.1 A/point -Protection fu... More Details >>
Assignment for connecting two CC-Link...
X devices will be assigned as follows. (With this setting, 32 points are occupied per station.) - Station No. 1: X100 to X11F -Station No. 2: X120 to X13... More Details >>
SB/SW refresh device setting with CC-...
There are no problems even though the SB/SW refresh device has not been set. More Details >>
Extending the station-to-station dist...
Use the optical media converter DMS-1000SL(-DC) (manufactured by Mitsubishi Electric System & Service Co., Ltd.). You can extend the station-to-station dista... More Details >>
Limitation on the number of MELSOFT p...
In the TCP/IP connection, you can connect up to 17 MELSOFT products at the same time using a dedicated connection for system and the connections for users 1 ... More Details >>
Using Ethernet UTP cables for the CC-...
Ethernet UTP cables cannot be used. More Details >>
Mixing line topologies with star topo...
Line topologies and star topologies can be mixed. More Details >>
Refresh timing of bit data and word d...
Cyclic data is sometimes separated into new and old data by two words (32 bits) with auto refresh timing. Checking "Block data assurance per station" of the ... More Details >>
Model name of the connector used for ...
FCN connectors (40-pin connector) are shown below.- A6CON1 (soldering connector)- A6CON2 (crimp connector)- A6CON3 (pressure-displacement connector)- A6CON4 ... More Details >>
Precaution about MELSECNET/H connecti...
- Set successive station numbers for the network modules in system A and system B in a redundant system. (Station number 0 cannot be set.) - Match "host... More Details >>
801-810 of Total 876