Main Unit | FAQ | MITSUBISHI ELECTRIC FA

Font Size
S
M
L

FAQ > Controllers > Programmable Controllers MELSEC > MELSEC-F Series > Main Unit

FAQ

Inquiries

Keyword Search

You can search two or more words separated by a space.

 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

Result Type

Text Search

FAQ within [ Main Unit ]

71-80 of Total 126

prev 8 / 13page next

Communications with a personal comput...

When a personal computer (GX Works2) is connected to the RS-232C port of a programmable controller, communications between the personal computer and the prog... More Details >>
- No：24782
- Release Date：2019/02/27 16:10
Maximum number of characters in a com...

As project data, up to 32 one-byte characters (16 two-byte characters) can be input to each global device comment. However, the maximum number of characters ... More Details >>
- No：24700
- Release Date：2019/02/27 08:59
Turning on a bit in the data register

In the FX3U/FX3UC series, the bit specification of the data register is possible. (Example) D0.7→7th bit in D0 For the other types of MELSEC-F programmable... More Details >>
- No：22275
- Release Date：2018/08/30 13:48
Operation processing time of the prog...

The constant operation processing time can be achieved by using constant scan mode. Refer to the programming manual of the programmable controller used. More Details >>
- No：24997
- Release Date：2019/04/23 10:38
Operation of the first special functi...

Usually, unit number of the first special function unit/block is "K0". However, when the main unit is FX3UC-32MT-LT(-LT2), the unit number "K0" is assigned t... More Details >>
- No：24995
- Release Date：2019/04/23 10:40
Supported versions of the FX3U/FX3UC ...

The main units with Ver.3.10 or later can read and write programs of the FX3 series connected to the intelligent device station and can monitor devices. (GX ... More Details >>
- No：24990
- Release Date：2019/04/23 10:37
Instruction execution complete flag

When a flag contact is not programmed directly under the instruction to be checked, the flag may be turned off depending on the execution status of another i... More Details >>
- No：24988
- Release Date：2019/04/23 07:22
M8037 (forced STOP signal)

Yes, it is possible. To set the programmable controller to RUN again, while the programmable controller is stopped, set the built-in RUN/STOP switch as follo... More Details >>
- No：24965
- Release Date：2019/04/23 07:18
Index modifier of bit devices in the ...

The FX3G series does not support the index modifier for the bit devices. The FX3U/FX3UC series supports this function. More Details >>
- No：24959
- Release Date：2019/04/18 14:35
Communication format setting

The communication format can be set in the communication setting of a sequence program or "PLC Parameter setting" using GX Developer. To avoid setting troub... More Details >>
- No：24929
- Release Date：2019/04/17 11:42

71-80 of Total 126

page top

OKWave logo

PRAZNA logo