You can use general-purpose three-phase induction motors.You can also use geared motors if the motor itself is an induct

When consuming the regenerative power with the brake resistor, the brake transistor is triggered at a certain voltage to

The parameters of the A500 series are stored in the EEPROM.The reason why all parameters returned to the initial values

If you are using an external VR, influence by noise is probable.Setting Pr.74 (Input filter time constant) to a higher v

Keep 1 cm or more of clearance for 3.7 K or smaller, and 5 cm or more for 5.5 K or larger.If the clearance is too small,

When an instantaneous power failure occurs and the inverter's bus voltage drops below the standard value, it outputs an

Yes. Set Pr.79 = 3. (Input the start signal from an external source.)

Check the parameters necessary for tuning again.Check if Pr.9 (Electronic thermal O/L relay) and Pr.81 (Number of motor

The whole system consists of the power supply, molded case circuit breaker, high power factor converter, inverter, and m

Since the inverter displayed "0.00" instead of an error when the inverter speed dropped to 0 Hz and stopped by holding t

FAQ

FAQAbout Products

Font Size
S
M
L

FAQ > Drive Products

FAQ

Inquiries

Keyword Search

You can search two or more words separated by a space.

 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

Result Type

Text Search

Drive Products

Geared Motors(86)

Geared Motors Parallel shaft type(23)
Geared Motors Right angle shaft type(25)
S-PM Geared Motors Parallel shaft type(18)
S-PM Geared Motors Right angle shaft type(20)

FAQ within [ Drive Products ]

1031-1040 of Total 1353

prev 104 / 136page next

Which motors can I use with the inverter?

You can use general-purpose three-phase induction motors.You can also use geared motors if the motor itself is an induction motor.Synchronous motors are not ... More Details >>
- No：22081
- Release Date：2018/08/22 16:30
- Category： Inverters-FREQROL
Permissible brake duty

When consuming the regenerative power with the brake resistor, the brake transistor is triggered at a certain voltage to make the brake resistor use the rege... More Details >>
- No：22074
- Release Date：2018/08/22 16:30
- Category： Inverters-FREQROL , FREQROL-E500
All parameters returned to initial values

The parameters of the A500 series are stored in the EEPROM.The reason why all parameters returned to the initial values is considered that you may have opera... More Details >>
- No：22066
- Release Date：2018/08/22 16:30
- Category： Inverters-FREQROL , FREQROL-A500
Frequency display deviation

If you are using an external VR, influence by noise is probable.Setting Pr.74 (Input filter time constant) to a higher value stabilizes the frequency command... More Details >>
- No：22061
- Release Date：2018/08/22 16:30
- Category： Inverters-FREQROL , FREQROL-E500
Installation clearance of inverters

Keep 1 cm or more of clearance for 3.7 K or smaller, and 5 cm or more for 5.5 K or larger.If the clearance is too small, the cooling effect is lowered. Secur... More Details >>
- No：22046
- Release Date：2018/08/22 16:30
- Category： Inverters-FREQROL , FREQROL-A500
Relationship between undervoltage warning and instantaneous power failure

When an instantaneous power failure occurs and the inverter's bus voltage drops below the standard value, it outputs an undervoltage warning and stops its ou... More Details >>
- No：21974
- Release Date：2018/08/22 16:30
- Category： Inverters-FREQROL , FREQROL-U100
Using built-in potentiometer and multi-speed together

Yes. Set Pr.79 = 3. (Input the start signal from an external source.) More Details >>
- No：21950
- Release Date：2018/08/22 16:30
- Category： Inverters-FREQROL , FREQROL-E500
Advanced magnetic flux vector control

Check the parameters necessary for tuning again.Check if Pr.9 (Electronic thermal O/L relay) and Pr.81 (Number of motor poles) are set correctly. More Details >>
- No：21754
- Release Date：2018/08/22 16:29
- Category： Inverters-FREQROL , FREQROL-E700 , FREQROL-A700
System configuration

The whole system consists of the power supply, molded case circuit breaker, high power factor converter, inverter, and motor. The high power factor converter... More Details >>
- No：21575
- Release Date：2018/08/22 16:28
- Category： Inverters-FREQROL , Options
Speed does not exceed 46 Hz

Since the inverter displayed "0.00" instead of an error when the inverter speed dropped to 0 Hz and stopped by holding the winding machine by hand, it is con... More Details >>
- No：21492
- Release Date：2018/08/22 16:27
- Category： Inverters-FREQROL , FREQROL-E500

1031-1040 of Total 1353

Inquiries

page top