Emergency stop of the FR-A800

For the V/F control and Advanced magnetic flux vector control, the FR-A800 stops only by Pr.1103 Deceleration time at emergency stop. Pr.815 is not affected. More Details >>

Brake resistor GRZG

It is not supported but can be used. Passive elements such as reactors and brake resistors are out of the scope of the KC (Radio Waves Act (South Korea)). More Details >>

Analog output

The FM output is 0 to 8 VDC pulse. More Details >>

400 Hz output setting

Change Pr.18 (High speed maximum frequency) to 400 Hz.If you are using the analog command to set the frequency, calibrate the 400 Hz frequency with Pr.903. More Details >>

Frequency setting

Use the setting dial to set the frequency with the FR-E700.You can also use the setting dial to set the parameters.(By setting Pr.161, you can use the settin... More Details >>

FR-E740

The following is the amount of heat generated for each capacity:0.4K: 40W　　0.75K: 55W　　1.5K: 90W　　2.2K: 100W3.7K: 180W　　5.5K: 240W　　7.5K: 300W　　11K: 400W15K:... More Details >>

Use of general-purpose servo motor

You can operate it by adjusting the motor constant by the auto tuning function. (Note that the same characteristics as operated by the servo amplifier MR-VA ... More Details >>

DIN rail installation

You can do it by using the optional DIN rail attachment (FR-DU01/02). More Details >>

Can I use digital operation panel FR-DU01?

You cannot use it with the standard and multi-function products. It can be connected to the dedicated PU operation type only. (Note that the FR-DU01 is an op... More Details >>

DIN rail installation

Unit type: SC-A□□U can be installed on the DIN rail. Box type: SC-A□□B cannot be installed on the DIN rail. More Details >>