Interval of next power ON

The instantaneous power failure error occurs when the power is turned ON instantaneously (within 100 ms) after the power is turned OFF. When the motor is coa... More Details >>

Amount of heat generated

The amount of heat generated by the FR-E500 series inverter is registered in the Mitsubishi Electric FA Global Website Member's page. Refer to the technical ... More Details >>

Remote operation of the inverter

The wiring length of the start signal (STF etc.) is 30 m or less. The circuit voltage of the control input signals (terminal STF etc.) is 24 VDC and the volt... More Details >>

Wiring of CC-Link communication cable

The communication is established if DA, DB, and DG are connected each other. More Details >>

Remote input signal of CC-Link communication

When the communication error occurs, the input signal status is not retained, and all the bits turn OFF. When the communication establishes again, the bit tu... More Details >>

Remote register when instruction code execution request is issued at CC-Link communication

The value "0" is stored. More Details >>

Writing set frequency by CC-Link communication

No error will occur because up to 400 Hz that is the upper limit of the setting range can be written. More Details >>

FR-HC2

It is fundamentally the same as the conventional model. Considering the recent safety awareness growth, we decided to start supporting it from the FR-HC2. Be... More Details >>

FR Configurator

Data with different capacity can be imported. Data with different voltage or model cannot be imported. More Details >>

FR Configurator (English version)

The English version cannot be updated from the Website. FR-SW3-SETUP-WE needs to be purchased. More Details >>