FR-F800

Yes, it does, however, it does not acquire the certification of the BACnet association standard. More Details >>

STOP function of the FR-A800

No, it is not. It is released by the inverter reset that releases E.OHT. More Details >>

Fault contact when connecting separate power supply for each control circuit

Since the inverter's fault contact is an NC contact, it does not open unless a fault occurs.Therefore, when the control power supply (and main circuit power ... More Details >>

Reset selection

The specifications of the FR-V200E series do not allow for choosing from "Reset input always enabled" and "Reset input enabled only when the protective funct... More Details >>

Peripheral device selection

1. Select the circuit breaker and MC in accordance with the inverter type.2. Select the power factor improving reactor in accordance with the motor output. More Details >>

Electronic thermal O/L relay setting

Set Pr.9 to the rated current at 50 Hz or a value 1.1 times as the rated current at 60 Hz.You can specify the motor type with Pr.71 (Applied motor). For a co... More Details >>

400 Hz output setting

Change Pr.18 (High speed maximum frequency) to 400 Hz.If you are using the analog command to set the frequency, calibrate the 400 Hz frequency with Pr.903. More Details >>

Comparison of noise with FR-A200

The setting ranges of the carrier frequency are:- FR-A200: 2 kHz to 14.5 kHz- FR-A200EXCELLENT: 0.7 kHz to 14.5 kHzThe range of the FR-A200E is extended to t... More Details >>

Can I use digital operation panel FR-DU01?

You cannot use it with the standard and multi-function products. It can be connected to the dedicated PU operation type only. (Note that the FR-DU01 is an op... More Details >>

DIN rail installation

Unit type: SC-A□□U can be installed on the DIN rail. Box type: SC-A□□B cannot be installed on the DIN rail. More Details >>