Can I connect it to high power factor converter?

It can be connected to an inverter that supports the high power factor converter FR-HC. (It cannot be connected to conventional inverters.) How to identify i... More Details >>

What happens if the supplied reactor and outside box are not used?

Harmonics cannot be suppressed (controlled) correctly and noise cannot be removed. Be sure to connect the supplied reactor and outside box to the inverter. More Details >>

Torque characteristic at low speed

Torque is not guaranteed for slower than 0.5 Hz. Therefore, no data for this is published. Also, no torque is generated at 0 Hz. More Details >>

Using control power supply

You cannot disable the error display. The OC1 overcurrent alarm is displayed. The condition to display this alarm is that the main circuit power supply is OF... More Details >>

Is this a failure?

The following are check points for abnormal conditions in addition to those given in the FR-Z200 manual. 　1. Are the forward and reverse signals input simult... More Details >>

Coasting

When the inverter output shutoff signal MRS is turned on, the output is shut off immediately without regard to setting of Pr.250. More Details >>

Inverter installation when using the FR-A7NCE

Normally, the required space for A700 3.7K or lower is 1 cm. However, when using CC-Link IE, it needs to be separated for 5 cm or more to pass the cable. More Details >>

FR-A8TP

Yes. More Details >>

Instruction manual of capacity selection software

You can download the instruction manual from the Mitsubishi Electric FA Global Website. Visit the Mitsubishi Electric FA Global Website and go to [Download]... More Details >>

Current value monitor indicator

The measurable frequency range and measurement precision of the inverter's output current greatly differ depending on the measurement instrument.Check with t... More Details >>