FR-E710W

Yes. The model is FR-E710W. The input is single-phase 100 V, but the output is three-phase 200 V. More Details >>

Amount of heat generated

The amount of heat generated by the FR-E500 series inverter is registered in the Mitsubishi Electric FA Global Website Member's page. Refer to the technical ... More Details >>

Priority of multi-speed setting and frequency setting signals

For frequency setting, multi-speed setting is prioritized over current input. Therefore, when the multi-speed signal is input, the inverter switch to multi-s... More Details >>

Can I use the parameter unit FR-PU02?

Yes, but functions are partially limited. (The FR-PU02 cannot demonstrate its full ability. The FR-PU01 cannot be used.) To use the parameter unit FR-PU02, u... More Details >>

CC-Link

Did you purchase the FR-A7NC?If the front cover is supplied with the FR-A7NC E kit, it will fit. More Details >>

Influence on inverter at motor coasts to stop

An induction motor does not act as a power generator unless voltage is applied to it.Therefore, just rotating due to coasting does not affect the inverter. More Details >>

When controlling motor with brake by inverter

Use the RUN signal to turn ON and OFF the brake.Using the MRS (output shutoff) signal to turn ON the brake shuts off the inverter's output and reduces influe... More Details >>

Rated capacity related to harmonic suppression guidelines

The usual inverter input current is determined not by the inverter capacity but by the motor capacity (motor load).Therefore, the input side capacity is not ... More Details >>

Fault output terminal load pattern

The fault output terminals A and C, and B and C of the power regeneration converter FR-RC are not capable of a micro load of 5 VDC±5%, 10 mA. The minimum loa... More Details >>

Fault output contact rating

They are capable of a load of 5 VDC±5% and 10 mA. More Details >>