Cumulative power monitoring

They are cleared as well. More Details >>

PID control of CC-Link communication

When performing the PID control by CC-Link communication, the X14 signal is disabled. More Details >>

FR-E710W

Yes. The model is FR-E710W. The input is single-phase 100 V, but the output is three-phase 200 V. More Details >>

Motor characteristics at low input voltage

Since the dedicated motor is designed with the rated voltage of approximately 320 V, it can produce sufficient torque for the input voltage of 380 V. Therefo... More Details >>

Compressor

You can use an inverter for fan and pump with the compressor, but it is not recommended for an application that the motor load rapidly increases. More Details >>

Shielded wiring of external speed setting potentiometer

Grounding can often get dirty due to influence from the inverter main circuit switching. Therefore, when the potentiometer shielded wire is connected to the ... More Details >>

Countermeasure against oil mist

1. You cannot use the inverter in an environment where it is exposed to oil mist. 　You need to enclose the inverter in an enclosure and then install the encl... More Details >>

Torque characteristic at low speed

Torque is not guaranteed for slower than 0.5 Hz. Therefore, no data for this is published. Also, no torque is generated at 0 Hz. More Details >>

Can I use digital operation panel FR-DU01?

You cannot use it with the standard and multi-function products. It can be connected to the dedicated PU operation type only. (Note that the FR-DU01 is an op... More Details >>

Installation of new serial communication unit FR-CU03

Remove the parameter unit FR-PU03 and install there. (The installation dimensions of the FR-CU03 are the same as the FR-PU.) You can read and write parameter... More Details >>