CC-Link

Input 4 words, output 4 words for version 1. 2, 4, and 8 times for version 2. More Details >>

Operation panel for FR-E500

The operation panel FR-PA02 for the FR-E500 can be used for these models.You need the FR-E5P (back cover adapter set) and FR-C20□ (connection cable) for the ... More Details >>

CC-Link

The start commands cannot be input from both sources simultaneously because the operation command source is specified.You can switch the command source as ne... More Details >>

Compatibility of the function with FR-A200

Yes. Compared with the FR-A200:- The auto tuning function is added.- Response current limit operation is improved.- The carrier frequency range is extended. ... More Details >>

Carrier frequency of low-noise series

The carrier frequency is initially set to 7 kHz. (When Pr.10 is set to "---", you can set or change the setting using Pr.72.) Raising the carrier frequency r... More Details >>

Regenerative power flow

If all inverters are in regenerative operation, the regenerative power is regenerated to the power supply. If one of the inverters is power driving, the rege... More Details >>

Noise filter

Noise filtering and harmonics suppression are different matters and you need to install the line noise filter (FR-BSF01) against noise and DCL (FR-BEL) again... More Details >>

Difference between use with A100 and other types

Similarly to the FR-A200 and A500, four or more filters should be used also for the FR-A100. 　In short, it is OK if the wire penetrates the filter four times... More Details >>

Inverter signal input speed

There is a 10 ms delay after the inverter recognizes the start command (STF OR STR) before it starts decelerating. The delay is 10 ms. A delay of 100 ms is i... More Details >>

Monitor

The output current monitor of the inverter displays the output current effective value of the three phases measured by the current sensor. It does not displa... More Details >>