Parameter list

The setting memo of the parameter list seal is not provided with the FR-A500 Instruction Manual. More Details >>

Compatibility with Y-△ motor and others

1. You can connect them using △ connection. 2. No problem with connecting four Y-△ motors. (Connect all four motors using △ connection.) (Note that the inver... More Details >>

Motor heat generation at low-speed operation

When using the FR-A540-3.7K in Advanced magnetic flux vector control, operating the motor continuously under the 100% torque at up to 3 Hz does not cause a h... More Details >>

Inverter loss

The inverter efficiency changes depending on the inverter output frequency, carrier frequency, motor capacity, and load factor. When the inverter and motor h... More Details >>

No load current value of motor

No load current for each power supply voltage is as follows:- Approximately 15.5 A for 200 VAC 60 Hz- Approximately 21.7 A for 220 VAC 60 HzThe current is es... More Details >>

Can I input speed setting externally with the box type?

No. Use the potentiometer on the box to set the speed. If you want to input analog values externally to set the speed, use the unit (module) type. More Details >>

What types are available?

The box type, unit type, and module type are available. Each has the following series:100 V series (40 W and 100 W)200 V series (40 W, 100 W, 200 W, and 400 ... More Details >>

DIN rail installation

You can do it by using the optional DIN rail attachment (FR-DU01/02). More Details >>

Do noise and leakage current increase?

During non-low-noise operation (initial setting) with the carrier frequency of 1 kHz, both noise and leakage current levels are almost same as the Z024 serie... More Details >>

Comparison of noise with FR-A200

The setting ranges of the carrier frequency are:- FR-A200: 2 kHz to 14.5 kHz- FR-A200EXCELLENT: 0.7 kHz to 14.5 kHzThe range of the FR-A200E is extended to t... More Details >>