FR-SW3 CC-Link Seamless

From before, the QCPU has been used and each setting does not make a difference internally. Thus, the selection was reduced to the QCPU only. It can also be ... More Details >>

FR-E700KNC

The inverter is reset. More Details >>

FR-HC2

No OL signal is output. More Details >>

FR-A800-R2R

They cannot be set with the frequency. Because the command is input at the line speed, consider the line speed of the initial winding diameter at 20 Hz. The ... More Details >>

FR-A800-R2R

It is possible when the dancer control and tension sensor feedback speed control is used and the PID calculation is turned OFF. Because the PID compensation ... More Details >>

FR-A800-R2R

The encoder feedback is always required for the thickness calculation function. The actual line speed calculation function requires the input of the actual l... More Details >>

FR-A800-R2R

If Pr.361 = 0, the second terminal can be used as the line speed command when X114 is ON, and as the frequency setting value when X114 is OFF. If Pr.361 = 3,... More Details >>

FR-A8NC

Yes. Use the coated model, FR-A8NC-60. More Details >>

Load characteristics fault detection

Only the V/F control is related with Pr.56. The motor torque is calculated from the current value (not Pr.56) and motor constant. For the V/F control, it is ... More Details >>

FR-A800-E

It is available if the CC-Link option of the FR-A8NC is installed. More Details >>