CC-Link

Yes, but the optional kit (FR-A7NC E kit) is necessary. More Details >>

Frequency setting

Use the setting dial to set the frequency with the FR-E700.You can also use the setting dial to set the parameters.(By setting Pr.161, you can use the settin... More Details >>

Motor with reduction gears

We can manufacture magnet motors with reduction gears.We have no catalog of them.Contact our sales representative for details. More Details >>

Manual contactor on output side of drive unit

The low-voltage manual contactor is intended to prevent electric shock during inspection and maintenance of the drive unit.The MELIPM series motor is a synch... More Details >>

Installation method of AM-5 terminal ammeter

The AM-5 output is 0 to 10 VDC voltage output.Therefore, you need to install a voltmeter.Also, since the inverter output current is displayed, the scale of t... More Details >>

Changing main speed at analog signal input

To change the running frequency while the frequency command is input to the terminal 2, adjust the parameters in the following steps:1. Change Pr.77 to "2".2... More Details >>

Output voltage measurement

The inverter's output voltage is controlled by switching DC voltage and has a pulse voltage waveform.(It is not a clean sine wave.)Therefore, it cannot be me... More Details >>

Winding control

As an example, you can use an inverter to feed the cord at the constant speed under dancer control using a combination of the deviation detector and deviatio... More Details >>

Separation of operation panel

The operation panel of the FR-S500 is not detachable.For the FR-S500-○○K-R (compatible with RS-485 communication), you can install the FR-PU04 on the enclosu... More Details >>

“off” is shown in the display.

Operation mode for manufacturer setting is enabled. For MR-J4-B, MR-J4W2-B and MR-J4W3-B, turning "ON (up)" all the control axis setting switches (SW2) enabl... More Details >>