FR-E720S-NC

It is available on request as a dedicated product. Contact your sales representative. More Details >>

Can I use it with single-phase 200 V input?

You can use it with the single-phase 200 V input by increasing the speed controller capacity to one-rank higher than the motor capacity. (Output is three-pha... More Details >>

Difference from conventional product (parameter unit)

The parameter unit is not available. Use two internal potentiometers to set the electronic thermal O/L relay and acceleration/deceleration time, and two swit... More Details >>

Do noise and leakage current increase?

During non-low-noise operation (initial setting) with the carrier frequency of 1 kHz, both noise and leakage current levels are almost same as the Z024 serie... More Details >>

Can a brake resistor or brake unit be connected?

You can connect them to the FR-A024 inverter 0.4 to 3.7K. (You cannot connect them to 0.1K and 0.2K.)Available brake resistor options include the FR-ABR high... More Details >>

Parameter unit FR-PU03

You can use it with the FR-A200 (E) and FR-A100 (E) series. (Note) Use the connection cable (option). You cannot use it with the FR-Z and FR-U series (except... More Details >>

Frequency setting

Since Advanced magnetic flux vector control is chosen, the inverter calculates how much the motor rotation slips from the flowing current and adds the slip a... More Details >>

Setting dial and FR-PA02 built-in potentiometer

When the FR-PA02 is connected to the inverter with a cable, the FR-PA02 becomes effective.The operation panel of the inverter can also be used to set some pa... More Details >>

FR-PA02 built-in potentiometer

Change Pr.146 (Built-in potentiometer switching) to "0" (built-in frequency setting potentiometer). More Details >>

CC-Link

Up to 42 units can be connected. (When only inverters are connected) More Details >>