Analog output

The FM output is 0 to 8 VDC pulse. More Details >>

Fault contact when connecting separate power supply for each control circuit

Since the inverter's fault contact is an NC contact, it does not open unless a fault occurs.Therefore, when the control power supply (and main circuit power ... More Details >>

Two-rank up maximum short-time torque

It is not possible to generate torque larger than the maximum possible torque of the motor by increasing the inverter's capacity.Even when the inverter is up... More Details >>

Influence by PHS

PHS does not cause the inverter to malfunction.On the contrary, if you use PHS near an inverter or motor, communication over PHS may become noisy or even get... More Details >>

400 Hz output setting

Change Pr.18 (High speed maximum frequency) to 400 Hz.If you are using the analog command to set the frequency, calibrate the 400 Hz frequency with Pr.903. More Details >>

Frequency setting

When running the inverter in Advanced magnetic flux vector control, the frequency setting value is increased by the amount of the motor's slippage, resulting... More Details >>

Auto tuning

Check if any device is connected to the inverter's external terminal.In particular, check if MRS and SD are short-circuited.If they are short-circuited, open... More Details >>

FR-E720

The following is the amount of heat generated for each capacity:0.1K: 14W　　0.2K: 20W　　0.4K: 32W　　0.75K: 50W1.5K: 80W　　2.2K: 100W　　3.7K: 160W　　5.5K: 290W7.5K:... More Details >>

FR-PA07, FR-CB203

Yes. More Details >>

Cycle operation mode, continuous operation mode, torque characteristic selection

When using a motor with an encoder by performing auto tuning, you need to choose the operation mode or continuous operation mode depending on the application... More Details >>