Inverter selection when driving multiple motors

When driving multiple motors with a single inverter, determine the inverter capacity in one of the following two methods:1. When driving multiple motors conn... More Details >>

Fault output contact rating

They are capable of a load of 5 VDC±5% and 10 mA. More Details >>

External wiring for CC-Link operation

For the combination of the FR-A500 + FR-A5NC, Pr.338 and Pr.339 are used to specify whether the external signals or CC-Link commands are used to set the runn... More Details >>

Speed 2 operation with potentiometer on operation panel

Yes. Set parameters as below.For FR-E500Set Pr.79 =3, and Pr.146= 0.Multi-speed is prioritized.For FR-S500Set Pr.79 = 3, and Pr.53 = 1.Multi-speed is priorit... More Details >>

Clutch connection of load

Since a large load is applied to the motor when the electromagnetic clutch turns on, overcurrent may occur if the load is heavy. To ensure that the rated cur... More Details >>

Frequency setting

Use the setting dial to set the frequency with the FR-E700.You can also use the setting dial to set the parameters.(By setting Pr.161, you can use the settin... More Details >>

CC-Link

Yes, but the optional kit (FR-A7NC E kit) is necessary. More Details >>

Operation panel for FR-E500

The operation panel FR-PA02 for the FR-E500 can be used for these models.You need the FR-E5P (back cover adapter set) and FR-C20□ (connection cable) for the ... More Details >>

FR-E700

Use Pr.C24 (Frequency setting voltage gain frequency built-in potentiometer). More Details >>

Advanced magnetic flux vector control

When using the geared motor GM-S(B), set Pr.71 to "13" and also set Pr.9, Pr.80, and Pr.81.Perform auto tuning as required. Perform auto tuning as required. ... More Details >>