The English version cannot be updated from the Website. FR-SW3-SETUP-WE needs to be purchased.

Inverters with the components fixed on the circuit board with an adhesive, an countermeasure against the connector faili

The warning "Do not use a magnetic contactor on the inverter input for frequent starting/stopping of the inverter." is i

You can connect them in parallel. Connect the voltmeters in parallel, paying attention to the following: - The output cu

1. The inverter display is based on the frequency, and the speed and moving speed are displayed by converting the freque

There is a 10 ms delay after the inverter recognizes the start command (STF OR STR) before it starts decelerating. The d

Grounding can often get dirty due to influence from the inverter main circuit switching. Therefore, when the potentiomet

1. As the measurement condition is unknown, the possible cases are as follows: - If you measured the current on the inp

When using the FR-A540-3.7K in Advanced magnetic flux vector control, operating the motor continuously under the 100% to

The 0.75 kW inverter with the single-phase 100 V power supply can be manufactured and is actually commercialized as the

FAQ

FAQAbout Products

Font Size
S
M
L

FAQ > Drive Products

FAQ

Inquiries

Keyword Search

You can search two or more words separated by a space.

 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

Result Type

Text Search

Drive Products

Geared Motors(88)

Geared Motors Parallel shaft type(24)
Geared Motors Right angle shaft type(26)
S-PM Geared Motors Parallel shaft type(18)
S-PM Geared Motors Right angle shaft type(20)

FAQ within [ Drive Products ]

1-10 of Total 1368

prev 1 / 137page next

FR Configurator (English version)

The English version cannot be updated from the Website. FR-SW3-SETUP-WE needs to be purchased. More Details >>
- No：21195
- Release Date：2018/08/22 16:26
- Category： Inverters-FREQROL
FR-A800-CRN

Inverters with the components fixed on the circuit board with an adhesive, an countermeasure against the connector failing, or the cables tied (fixed) togeth... More Details >>
- No：20931
- Release Date：2018/08/22 16:25
- Category： Inverters-FREQROL
Direct driven start by power supply

The warning "Do not use a magnetic contactor on the inverter input for frequent starting/stopping of the inverter." is indicated in the precautions at the be... More Details >>
- No：21458
- Release Date：2018/08/22 16:27
- Category： Inverters-FREQROL , FREQROL-E500
Connecting voltmeter to terminal AM

You can connect them in parallel. Connect the voltmeters in parallel, paying attention to the following: - The output current should not exceed the permissib... More Details >>
- No：21464
- Release Date：2018/08/22 16:27
- Category： Inverters-FREQROL
Rotation speed setting

1. The inverter display is based on the frequency, and the speed and moving speed are displayed by converting the frequency into the corresponding value. The... More Details >>
- No：21480
- Release Date：2018/08/22 16:27
- Category： Inverters-FREQROL , FREQROL-A500
Inverter signal input speed

There is a 10 ms delay after the inverter recognizes the start command (STF OR STR) before it starts decelerating. The delay is 10 ms. A delay of 100 ms is i... More Details >>
- No：21445
- Release Date：2018/08/22 16:27
- Category： Inverters-FREQROL , FREQROL-A500
Shielded wiring of external speed setting potentiometer

Grounding can often get dirty due to influence from the inverter main circuit switching. Therefore, when the potentiometer shielded wire is connected to the ... More Details >>
- No：21455
- Release Date：2018/08/22 16:27
- Category： Inverters-FREQROL
Inverter current value

1. As the measurement condition is unknown, the possible cases are as follows: - If you measured the current on the input side of the inverter, since the cu... More Details >>
- No：21457
- Release Date：2018/08/22 16:27
- Category： Inverters-FREQROL
Motor heat generation at low-speed operation

When using the FR-A540-3.7K in Advanced magnetic flux vector control, operating the motor continuously under the 100% torque at up to 3 Hz does not cause a h... More Details >>
- No：21496
- Release Date：2018/08/22 16:27
- Category： Inverters-FREQROL , FREQROL-A500
Single-phase 100 V series

The 0.75 kW inverter with the single-phase 100 V power supply can be manufactured and is actually commercialized as the FR-U100 series. Manufacturing of the ... More Details >>
- No：21509
- Release Date：2018/08/22 16:28
- Category： Inverters-FREQROL

1-10 of Total 1368

Inquiries

page top