Regarding the compatible programming ...
GX Developer/GX Works2 cannot be used. MELSEC iQ-F series only supports GX Works3. More Details >>
Regarding simulation function using G...
For GX Works3 Ver.1.025B or later, the simulation function is supported. More Details >>
Regarding the method to check the sca...
The current value of the scan time is stored in the following special devices. Please monitor using GX Works3. ◇Scan information SD520 Current scan time (ms... More Details >>
Regarding selection of FX3 intelligen...
As the parameter settings of the FX3 intelligent function modules are not supported by GX Works3, they cannot be selected from the element selection window.... More Details >>
Regarding the cause of communication ...
From the Microsoft? Windows?7's Internet Protocol Version 4 Properties, uncheck "Obtain an IP address automatically" option and set an arbitrary IP adress th... More Details >>
Regarding a mismatch found in the mon...
Perform "Rebuild All" and initialize the memory before writing to the PLC. "Rebuild All" converts the entire project and "Convert" only coverts the modified ... More Details >>
From the following menu of GX Works3: [Diagnostics]→[Module Diagnostics(CPU Diagnostics)] the event history function can be found. The event history can disp... More Details >>
"Rebuild All" converts the entire project and "Convet" only coverts the modified part of the program. More Details >>
Regarding the latch settings of data ...
It is necessary to set the latch range from the following GX Works3 parameters: [Navigation Window] -> [CPU Parameters] -> [Device/Memory Settings] -&... More Details >>
Regarding communication with MX Compo...
Communication can be established with MX Component Ver4.09 or later. Also, both serial and Ethernet communications are supported. More Details >>
1-10 of Total 15