Connecting AJ65BT-R2N to a GOT

Yes.When connecting a GOT, set the mode setting switch of AJ65BT-R2N to "5" (MELSOFT connection mode). More Details >>

Connecting terminating resistors for ...

Connect terminating resistors to both ends of physical cables.A master station is not necessarily required to be connected to either end of its network. More Details >>

Applicable size for plug-in connector...

Use the plate terminal packaged with the module. The size of the plate terminal is 1.0 mm wide with a thickness of 0.8 mm. More Details >>

Limitation on the number of levels of...

If a repeater hub is used, 10BASE-T allows a maximum of four levels of cascade connections and 100BASE-TX allows a maximum of two levels of cascade connectio... More Details >>

Connecting QJ71C24N to an external de...

Carry out DTR and DSR wiring that returns signals on QJ71C24N(-R2). More Details >>

Receiving data when no receive comple...

Data are received on a received data count basis. If there is no receive complete code and variable length data is received, the data is received at every no... More Details >>

Assigning X and Y signals of AJ65SBTB...

X and Y assignments are as follows.- X0 to XF- Y10 to Y1F More Details >>

Overall cable distance and station-to...

The overall cable distance and station-to-station distance depend on the version and the transmission speed. Figure 1 shows the case with Ver.1.10-compatibl... More Details >>

Cables for CC-Link networks

Use CC-Link dedicated cables. General-purpose cables cannot be used. More Details >>

Seamless communications

The CC-Link family products allow flexible programming and maintenance from any controllers for all the devices in connection. Such a communication, for whic... More Details >>