Start main contents

  • Font Size
  • S
  • M
  • L

FAQ within [ Options ]

11-20 of Total 129

prev 2 / 13page next
  • Sine wave filter

    The sine wave filter can be applied only under V/F control. When Pr.72 PWM frequency selection is set to 25, V/F control is set automatically. The applicable... More Details >>

    • No:21068
    • Release Date:2018/08/22 16:25
  • Built-in reactor

    The reactor built in the FREQROL-A201 series is intended to stabilize operation of the converter circuit and differs from the FR-BAL. Note that when performi... More Details >>

    • No:21421
    • Release Date:2018/08/22 16:27
  • Noise filter

    Noise filtering and harmonics suppression are different matters and you need to install the line noise filter (FR-BSF01) against noise and DCL (FR-BEL) again... More Details >>

    • No:21548
    • Release Date:2018/08/22 16:28
  • Synchronous operation of two motors

    When synchronously operating two motors, you need to detect speed from both motors. Each inverter is controlled based on this speed detection signal. As an e... More Details >>

    • No:21540
    • Release Date:2018/08/22 16:28
  • Copy function

    No. (Using the copy function causes an error.) Use the FR-DU08 when performing the copy function of the operation panel. More Details >>

    • No:21118
    • Release Date:2018/08/22 16:26
  • Replacement of FR-Z100 series

    From Z100 to A520: Use the FR-AAT01 to replace the Z100 with the A520. From Z100 to E520: No attachment is available since E520 is a new series. From Z100 to... More Details >>

    • No:21447
    • Release Date:2018/08/22 16:27
  • FR-PA07

    No, it cannot. The standard operation panel (FR-DU08) can be connected to the face of the board by using the FR-ADP (operation panel connection connector) an... More Details >>

    • No:20898
    • Release Date:2018/08/22 16:24
  • Installation of the FR-PA07

    Yes, because the same enclosure cut dimensions is adopted. More Details >>

    • No:20866
    • Release Date:2018/08/22 16:24
  • FR-HC/FR-HC2

    No, it cannot. Use the FR-HC2 dedicated reactor and outside box. More Details >>

    • No:20807
    • Release Date:2018/08/22 16:24
  • Analog ammeter

    We recommend the "YM206RI 1 mA" analog ammeter. More Details >>

    • No:21402
    • Release Date:2018/08/22 16:27

11-20 of Total 129